The first process: the design provided by the printing designer will be handed over to the professional plate-making company, and the film will be produced according to the requirements. Each color must be made of one film, so it is not advisable to design the T-shirt with too many colors, the more colors The higher the cost. The selenium plate of the film will be made, and it is also a selenium plate for one color. The selenium plate must be carefully inspected. You can print the pattern on the table with white powder first, and repair it with water in some places.
The second process: adjusting the propeller. According to the design draft, use the color card to find the corresponding color card number. Each color has a corresponding toning instruction, such as what proportion of green pigment and yellow pigment to use. According to the proportion, call out the glue of the required color. Pour the adjusted glue into the silk screen, mix thoroughly, press it on the paved T-shirt cut piece, and brush it back and forth with a wooden plate.
The third process: first locate the proof, find the center point, and the position of the pattern away from the neckline, make a mark. The cut piece of the T-shirt is laid on the countertop according to the mark, and the countertop is coated with glue. On the countertop, avoid movement during the printing process. After lifting the screen plate, wait for the glue to dry, and then brush the second pass. After finishing one set of colors, apply the second and third sets of colors.
